Filter
Top Products
12
(Continued on following page)
WARNING:
Mounting
screws must be used. Failure to
do so could result in the oven
falling out of the cabinet causing
serious injury.
Installation Instructions
Securing the Oven in the Opening
Drilling the Pilot Holes
and Mounting the Oven
a. Drill through the mounting holes (top and
bottom) of the side trim, for the #8 screws
provided.
b. Secure the oven to cabinet with screws
provided.
NOTE: If the cabinet is particle board, you
must use #8 x 3/4” (1.9 cm) particle board
screws. These may be purchased at any
hardware store.
Sliding the Oven Into
the Opening
a. Loop (do not tie) a 36” (91 cm) string
around the conduit before the oven is slid
into place. This will keep the conduit from
falling behind the oven.
b. Lift oven into cabinet cutout using the oven
opening as a grip. Carefully push against
oven front frame. Do not push against
outside edges.
c. As you slide the oven back, pull the string
so that the conduit will lie on top of the
oven in a natural loop.
d. When you are sure the conduit is out of the
way, slide the oven 3/4 way back into the
opening. Remove the string by pulling on
one end of the loop.
NOTE: Before drilling the pilot holes,
make sure the oven is pushed as far
back into the opening as it will go
and centered.
C
C1 C2
Pull out on
string loop
while pushing
the oven into
the cabinet
AVERTISSEMENT :
Des vis de montage doivent
être utilisées. Le défaut de se
conformer à cette directive peut
occasionner la chute de four et, par
voie de conséquence, des blessures
sévères.
The screws must
be a minimum of
1/4” (0.64 cm)
from the front
of the cutout.
Mounting
Hole
Locations