Filter
Top Products
8
Cabinetry
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior 23 1/2”
(59.7 cm) depth and 9 1/4” (23.5 cm) height.
• These Monogram Ovens require 3/4” (1.9
cm) overlap on both sides. Allow 1” (2.5 cm)
Min. for top overlap and clearance to upper
doors.
• The Monogram Warming Drawers require
5/8” (1.6 cm) overlap on all sides.
• When installing a Monogram Warming
Drawer below a single or double oven, a
separate 120V, 60 Hz, properly grounded
receptacle must be installed. Refer to
installation instructions packed with the
Warming Drawer for specific installation
requirements.
Frameless Cabinets
Whenever possible, order 30” (76.2 cm)
frameless cabinet with the cutout sided to fit
the oven. If using stock cabinets, additional
finished filler pieces may be required to
cover the opening.
• A stock frameless cabinet cutout width
may be up to 28 3/4” (73 cm). If necessary,
add 1/2” (1.3 cm) cleats to the sides, flush
with the front edge of the side panels to
accept mounting screws.
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
Cutout for Frameless Cabinets
A6
Single Oven Cutout
for Installation Over
a Monogram Warming
Drawer
A4
Double Oven Cutout
for Installation Over
a Monogram Warming
Drawer
A5
27 5/16”
(69.2 cm)
Max.
23 1/2”
(59.7 cm)
Min.
Inside
2” x 2” (5 cm x 5 cm) or
2” x 4” (5 cm x 10 cm)
Anti-Tip Block Against
Rear Wall, 9” (22.9 cm)
From Floor to Bottom
of Block
2” (5.1 cm)
Min.
Allow 5/8”
(1.5 cm)
Overlap
on All
Sides
1” (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
9” (22.9 cm)
Max.
28 1/2”
(72.4 cm).
51 15/16”
(131.8 cm)
Max.
23 1/2”
(59.7 cm)
Min.
Inside
2” x 2” (5 cm x
5 cm) or 2” x
4” (5 cm x 10
cm) Anti-Tip
Block Against
Rear Wall, 9”
(22.9 cm)
From Floor
to Bottom
of Block
2” (5.1 cm)
Min.
Allow 5/8”
(1.5 cm)
Overlap
on All
Sides
1” (2.5 cm) Min. Above Toekick
9” (22.9 cm)
Max.
28 1/2”
(72.4 cm)
Cabinet Depth
23 1/2” (59.7 cm)
Min. From Inside
Back to Front of
Cabinet Frame
or Side Panel
3/4” (1.9 cm) Min.
Thick Bottom Shelf
Cut Back Flush
with Front of
Side Panel
Install 1/2”
(1.3 cm)
Cleats to
Hold Oven
Mounting
Screws
30”
(76.2 cm)
28 1/2” (72.4 cm)
Min.
28 5/8” (72.7 cm)
Max.
Double
51 15/16” (131.8 cm)
Single
27 5/16” (69.2 cm)
9 1/4”
(23.5 cm).
9 1/4”
(23.5 cm).