Filter
Top Products
Connect a Booth Control to the RoboMix (to operate as a manual system)
12 313212A
Connect a Booth Control to the RoboMix (to operate
as a manual system)
To use the RoboMix as a manual system, order the
15V350 Booth Control Kit and connect as follows. The
kit includes a booth control module, wall bracket, and 50
ft (15.25 m) cable.
1. See F
IG. 13. Mount the booth control in a convenient
location near the RoboMix. Bring the cable to the
RoboMix and thread it through the cable path at the
back.
2. See the ProMix 2KS Repair-Parts manual. Open the
RoboMix to access the control board.
3. Connect the cable to J7 on the control board. Close
up the RoboMix and return to operation.
NOTICE
To avoid damaging circuit board when servicing, wear
grounding strap on wrist and ground appropriately.
FIG. 13. Connect a Booth Control to the RoboMix
TI12511a
TI15110a
Cable Path
RoboMix
Booth Control Cable
Booth Control
J7. Plug In for
Booth Control
Cable
RoboMix Control Board