Filter
Top Products
Installation
313855H 7
System Configuration and Wiring
The System Configuration Diagrams (FIG. 5 - FIG. 7), Sensor Wiring Diagrams (FIG. 8 - FIG. 10) and Wiring Diagrams
(F
IG. 11 - FIG. 16) on the following pages, show typical Injector, Divider Valve and Dual Line lubrication system config-
urations.
Refer to Table 1, 2 and 3 to determine the Required System Configuration, Sensor Configuration and Wiring Diagram
to use to setup your system.
Table 4 shows additional (optional) setup configurations (F
IG. 17 - FIG. 19).
Table 1: System Configurations
Table 2: Sensor Wiring Configurations
Table 3: Modes of Operation
Table 4: Optional I/O Wiring Diagrams
System Figure Page
Divider Valve 5 8
Dual Line 6 9
Injector 7 10
Sensor Figure Page
Dry Contact 8 11
Sourcing 9 11
Sinking 10 11
Mode Power Figure Page
Time ON/Time OFF DC 11 12
Time ON/Time OFF AC 12 12
Cycle ON or Pressure
ON/Time OFF
DC 13 13
Cycle ON or Pressure
ON/Time OFF
AC 14 13
Cycle ON or Pressure
ON/Machine Count
OFF
DC 15 14
Cycle ON or Pressure
ON/Machine Count
OFF
AC 16 14
System Mode Power Supply Wiring Diagram
Low Level Switch F
IG. 17, page 15
External Manual Run F
IG. 17, page 15
O.K. Contact Out F
IG. 17, page 15
Auxiliary and Low Level
Alarm Out
DC: FIG. 18, page 16
115/230 VAC: F
IG. 19, page 16