Filter
Top Products
Grandstream Networks, Inc. GXW40XX User Manual Page 16 of 38
Firmware 1.0.4.2 Last Updated: 06/2011
On the GXW4024 inter-port calling is achieved by dialing *** and 7 plus two extra digits corresponding to
the port number. For example the user connected to port 1 can be reached by dialing *** and 701; the
user connected to port 24 can be reached by dialing *** 724.
PSTN PASS THROUGH/LIFE LINE
This feature is only applicable to GXW4004 and GXW4008 models. The RJ-11 line jack on the
GXW400X side connected to a legacy PSTN line, functions as a pass through jack when the GXW400X
loses power or becomes unregistered. In this case, analog phone connected to FXS port 1 will be directly
connected to RJ-11 jack marked as LINE. The pass through/life line mode enables the user to use the
analog phone for PSTN calls directly without using an access code.
SENDING AND RECEIVING FAX
GXW40XX supports fax in two modes: 1) T.38 (Fax over IP) and 2) Fax Pass through. T.38 is the
preferred method because it is more reliable and works well in most network conditions. If the service
provider supports T.38, please use this method by selecting T.38 as fax mode
(default). If the service
provider does not support T.38, pass-through mode may be used. If you have problems with sending or
receiving Fax, toggle the Fax Tone Detection Mode setting.
SUPPORT RADIUS PROTOCOL
GXW40XX supports RADIUS for authentication, authorization and billing purposes. Primary and
secondary RADIUS server configurations are available to provide redundancy to this feature. In case
Primary Radius server becomes unusable, RADIUS requests will be automatically sent to the secondary
server. When at least one RADUIS server was configured, the device will allow users to make phone calls
only after authorization from RADIUS server has been received. CDR (Call Detail Record) is also sent to
the RADIUS server for billing purposes. RAIDUS server can send requests to terminate calls when run
out of pre-paid credit.
The GXW400x will be able to work in VoIP billing environment using redundant double server
configuration. User will be able to configure primary and secondary RADUIS server IP Addresses or
FQDNs. Once at least one RADUIS server was configured, the device will allow users to make phone
calls only after permission from RADIUS server has been received. In case Primary Radius server
becomes unusable, secondary will take role of primary and will manage credit recourses in the network.
Imbedded RADIUS client also supports request generated by
Radius server to terminate calls when run out of
pre-paid credit.