Filter
Top Products
Grandstream Networks, Inc. GXW40XX User Manual Page 25 of 38
Firmware 1.0.4.2 Last Updated: 06/2011
Firmware Key
For firmware encryption. It should be 32-
digit in Hexadecimal Representation. End
user should keep it blank.
SSL Certificate
The GXW40XX series supports SIP over TLS. It has built-in private key and SSL
certificate.
The user specified SSL certificate used for SIP over TLS is in X.509
format.
SSL Private Key
You may also customize the SSL Private Key. The user specified SSL private key
used for SIP over TLS is in X.509 format.
SSL Private Key Password
Enter SSL Private Key password here.
ACS URL
User specify the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username
User specify the ACS Username
ACS Password
User specify the ACS password
Periodic Inform Enable
Default is No. If set to YES, device will send inform packets to the ACS
Periodic Inform Interval
Frequency that the inform packets will be sent out to the ACS
Connection Request
Username
Set a user name for the ACS to connect to this device
Connection Request
Password
Set a password for the ACS to connect to this device
System Ring Cadence
Configuration option for all FXS ports ring cadence for all incoming calls.
(Syntax: c=on1/off1-on2/off2-on3/off3; [...])
Default is set to c=2000/4000; (US
standards)
Call Progress Tones
Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies.
Frequencies should be configured wit
h known values to avoid uncomfortable high
pitch sounds. ONis the period of ringing (ON time in ms) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring
ON ms and a pause of OFF ms and then repeat the pattern.
• “Dial tone”
• “Ringback tone”
• “Busy/Re-order tone”
• “Confirmation tone”
Please refer the document below to determine your local call progress tones:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Lock Keypad Update
If set to “Yes”, the configuration update via keypad is disabled.
Disable Voice Prompt
Disables the voice prompt configuration. Default is “No”. If set to “Yes” accessing
integrated voice menu will be impossible.
Disable Direct IP Call
Disables the Direct IP Call function. Default is “No”. If set to “Yes” direct IP-to-IP
calling will not be supported.