Filter
Top Products
Grandstream Networks, Inc. GXW40XX User Manual Page 24 of 38
Firmware 1.0.4.2 Last Updated: 06/2011
Via TFTP Server
This is the IP address of the configured TFTP server. If selected and it is non-
zero
or not blank, the GXW40XX
retrieves the new configuration file or new code image
from the specified TFTP server at boot time. After 5 attempts, the system will
timeout and the
n it will start the boot process using the existing code image in the
Flash memory. If a TFTP server is configured and a new code image is retrieved,
the new downloaded image is saved into the Flash memory.
Note: Do NOT interrupt the firmware upgrade pro
cess (especially the power
supply) as this will damage the device
. Depending on the network environment
this process may take up to 15 or 20 minutes.
Via HTTP or HTTPS Server
The URL for the HTTP server used for firmware upgrade and configuration via
HTTP.
Note: If Auto Upgrade is set to No, GXW40XX
will only do HTTP download once at
boot up.
Firmware Server Path
IP address or domain name of firmware server. That URL of the server that hosts the
firmware release. The default server is:
fm.grandstream.com/gs
Config Server Path
IP address or domain name of configuration server. The server hosts a copy of the
configuration file to be installed on the gateway.
The default server is:
fm.grandstream.com/gs
XML Config File Password
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User Name
The user name for the HTTP/HTTPS server.
HTTP/HTTPS Password
The password for the HTTP/HTTPS server.
Firmware File Prefix
Default is blank. If configured, GXW40XX will request firmware file with the prefix.
This setting is useful for Internet Telephone Service Providers. End users
should
keep it blank.
Firmware File Postfix
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Config File Prefix
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Config File Postfix
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Allow DHCP Option 66 to
override server
If set to “Yes”, configuration and upgrade server’s information can be obtained using
DHCP option 66 from DHCP server. This option specifies the URL of the tftp server.
Note:
If DHCP Option 66 is enabled, the gateway will attempt downloading a
configuration file from the server URL provided by DHCP, even though
Config
Server Path is left blank.
Automatic Upgrade
Choose “Yes” to enable automatic upgrade and provisioning.
When set to No,
GXW40XX will only do upgrade once at boot up.
When “Check every day” or “Check every week” is checked, user can specify “Hour
of the day (0-23)” or “Day of the week (0-6)”. Default time is Monday 1AM.
There are three options to choose from: “Always check for New Firmware
at Boot
up”, “Check New Firmware only when F/W pre/suffix changes”, and
“Always Skip the
Firmware Check”.
Authenticate Conf File
If set to Yes, configuration file is authenticated before being accepted. This protects
the configuration from unauthorized modifications.