Filter
Top Products
5
Powering Off GyroRemote
After 3 minutes of non-use, GyroRemote enters a Sleep Mode that conserves
battery life. In Sleep Mode the unit only uses battery power when a button is
pushed. It is not necessary to power down the unit when it is idle unless the
unit will be traveling and may encounter inadvertent button presses.
1. To power down GyroRemote, simultaneously press and release the
CHANNEL button and TEACH button on the side of unit. GyroRemote
will immediately enter deep sleep mode and will be unresponsive to
button clicks. The unit will confirm it is powering off by flashing its
LED three times.
2. Repeat this sequence to power the unit back on. The unit will
confirm it is powering on by flashing its LED for 1 second.
Note: It may be necessary to power off the unit when traveling on commercial airlines
due to FCC regulations regarding radio-emitting devices.
Installing or Replacing the Batteries
GyroRemote operates on four standard or alkaline
AAA batteries. When GyroRemote’s batteries reach
20% of a full charge the Status LED will blink when
it normally lights solid. For instance, clicking and
holding a button on a fully charged remote causes
the Status LED to light solid. Clicking and holding a
button on a remote with low batteries will cause the
Status LED to blink intermittently. To replace the
batteries:
1. From the bottom of the remote, slide the
battery cover open by pushing firmly
downward with your thumbs.
2. Remove the battery holder.
3. Insert four new AAA batteries into battery cradle and return cradle
into GyroRemote. When replacing the cradle into the remote, align
the positive (+) labels. See Illustration for proper cradle alignment.