Hearth and Home Technologies WSK-MLT Switch User Manual


  Open as PDF
of 7
 
2
WIRES WITH LABEL "FOR USE WITH WALL SWITCH
ONLY" (LOCATED UNDER FIREPLACE)
BROWN
YELLOW
or
WHITE
BLACK
TOGETHER
CONNECTED
FACTORY
FAN THERMOSTAT
YELLOW
YELLOW
FLAME ON
3V DC
GREEN
RED
BROWN
BLACK
GROUND
BROWN
ADAPTER WIRES
BLACK
RED
RED
BLACK
FLAME HIGH/LOW
SOLENOID
FLAME
MODULE
IPI
ORANGE
G
W*
R
8
7
6
5
4
3
2
1
BATTERIES
ORANGE
CONNECTION
FAN
PLUG
AC
BLACK
BLACK
G W* R
REAR VIEW
FRONT VIEW
CONNECTION
AUX
GREEN
PIGTAIL
GROUND
RED
RED
GREEN
ORANGE
VALVE
IPI
(MALE/FEMALE)
RED
RED
(FEMALE/MALE)
BLACK
RED
GROUND PIGTAIL
GREEN
BROWN
BROWN
USED
(LOCATED UNDER FIREPLACE)
WIRES WITH LABEL "FOR USE WITH
WALL SWITCH ONLY"
VALVE
FACTORY
CONNECTED
TOGETHER
PLUG
CONNECTION
AUX
BLACK
CONNECTION
FAN
YELLOW
FAN THERMOSTAT
FLAME
AC
FLAME HIGH/LOW
SOLENOID
ORANGE
BLACK
ORANGE
RED
RED
RED
BLACK
YELLOW
FRONT VIEW
W
RED
NOT
BLACK
G
REAR VIEW
R
R
W
YELLOW OR
WHITE
RED
GREEN
G
USED
NOT
Figure 2. Standing Pilot Wiring Diagram
Figure 3. Intellifi re (IPI) Wiring Diagram
to the electrical junction box and through a provided or
approved strain relief. Using a screw driver, connect the
red wire to the “R” terminal, the yellow or white wire to the
“W” or “Y” terminal, and the green wire to the “G” terminal.
Do not over-tighten. Using the screws provided, mount the
switch to the electrical junction box right side up. Install
provided cover plate using the screws provided. Do not
use a substitute cover even though it may fi t. The provided
one is specifi cally designed for the automatic (thermostat)
function of the unit.
1.2 Wiring the wall switch
Once a location is chosen and the electrical box is installed
proceed as follows. Install the provided control wire from the
fi replace to the switch location. (Control wire for Heatilator
products is supplied with the fi replace). Use caution not
to stress the wire around tight or sharp corners. Do not
run the control wire adjacent to existing or future phone,
data, cable, or electrical lines. The wire should not come
into contact with any part of the fi replace exterior with the
exception of where it exits the outer wrap. Feed the wire
For units WITH factory installed Rocker Switch
*May be labeled as “W” or “Y”.
*May be labeled as “W” or “Y”.
For units WITH factory installed Rocker Switch
*
*
 previous next