Filter
Top Products
8-8 HP Jetdirect Configuration Page Messages
LAN ERROR-
BABBLE
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off,
then on again. If the error persists, call the Customer
Care Center (see Chapter 1 for telephone numbers).
LAN ERROR-
CONTROLLER
CHIP
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off,
then on again. If the error persists, call the Customer
Care Center (see Chapter 1 for telephone numbers).
LAN ERROR-
EXTERNAL
LOOPBACK
The HP Jetdirect print server is incorrectly connected
to your network or is defective. Make sure your
HP Jetdirect print server is correctly attached to
your network. In addition, check the cabling.
LAN ERROR-LOSS
OF CARRIER
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off,
then on again. If the error persists, call the Customer
Care Center (see Chapter 1 for telephone numbers).
LAN ERROR-NO
LINKBEAT
This message is displayed if Link Beat is not sensed.
Check the network cable, and verify that the
concentrator/hub is providing Link Beat.
LAN ERROR-NO
SQE
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off,
then on again. If the error persists, call the Customer
Care Center (see Chapter 1 for telephone numbers).
LAN ERROR-
RECEIVER OFF
There may be a problem with your network cabling or
the HP Jetdirect print server. Check the cabling on your
Ethernet network. If you cannot find a problem with your
network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists after the
printer is turned on again, there is a problem with the
HP Jetdirect print server.
Table 8.2 General HP Jetdirect Messages (5 of 15)
Message Description
0Book-asF01.book Page 8 Tuesday, August 14, 2001 2:06 PM