Filter
Top Products
4.3.2 ROM (Read-Only Memory)
ROM contains default values that are set at the factory. They are called
default values because they are stored in ROM and cannot be changed. You
can load these default values into operating memory while in Menu Mode
using the procedure shown in Table 4–3.
NOTE: Default values loaded from ROM are temporary values, and are
affected if the printer receives a reset command or is powered off. If you
want to retain the default values, you must save them in NVRAM (see
Section 4.3.3).
Table 4–3: Recalling Factory Default Values from ROM
Operation Display Reads
1. Press
On Line
to place the
printer off line.
— The On Line indicator
shuts off.
00 READY
2. Press
Menu
to place the
printer in Menu Mode.
F
ONT/FEED LAYOUT
3. Press once. LOAD<–ROM FONT/F
4. Press
Enter
to
load the default
values from ROM.
OK (momentarily)
LOAD<–ROM FONT/F
5. Press
On Line
to place
the printer on line.
— The On Line indicator
lights.
00 READY
Printer Configuration 4–7