HP (Hewlett-Packard) 2626-PWR Switch User Manual


 
Power Over Ethernet (PoE) Operation for the Series 2600-PWR Switches
Viewing PoE Configuration and Status
Displaying the PoE Status on Specific Ports
Syntax:show power-management [e] < port-list >
Displays the following PoE status and statistics (since the last
reboot) for each port in < port-list >:
Power Enable: Shows Yes for ports enabled to support PoE (the
default) and No for ports on which PoE is disabled.
Priority: Lists the power priority (Low, High, and Critical)
configured on ports enabled for PoE. (For more on this topic,
refer to the power command description under
“Configuring
PoE Operation” on page 11-9.)
Detection Status:
Searching: The port is available to support a PD
connection.
Delivering: The port is delivering power to a PD.
Disabled: PoE support is disabled on the port. To re-enable
PoE support, refer to “Configuring PoE Operation” on
page 11-9.
Fault: The switch detects a problem with the connected PD.
Over Current Cnt: Shows the number of times a connected PD
has attempted to draw more than 15.4 watts. Each
occurrence generates an Event Log message.
Power Denied Cnt: Shows the number of times PDs requesting
power on the port have been denied due to insufficient power
available. Each occurrence generates an Event Log message.
Voltage: The total voltage, in dV, being delivered to PDs.
Power: The total power, in mW, being delivered to PDs.
Configured Type: Shows the type of PD detected on the port.
(Continued)
11-13