HP (Hewlett-Packard) 2626-PWR Switch User Manual


 
Monitoring and Analyzing Switch Operation
Status and Counters Data
Status and Counters Data
This section describes the status and counters screens available through the
switch console interface and/or the web browser interface.
Note You can access all console screens from the web browser interface via Telnet
to the console. Telnet access to the switch is available in the Device View
window under the Configuration tab.
Status or Counters Type Interface Purpose Page
Menu Access to Status and Menu
Counters
General System Information Menu, CLI
Management Address
Information
Module Information
Port Status
Port and Trunk Statistics
and Flow Control Status
VLAN Address Table
Port Address Table
STP Information
IGMP Status
VLAN Information
Port Status Overview and
Port Counters
Menu, CLI
Menu, CLI
Menu, CLI,
Web
Menu, CLI,
Web
Menu, CLI
Menu, CLI
Menu, CLI
Menu, CLI
Menu, CLI
Web
Access menu interface for status and counter data. B-5
Lists switch-level operating information. B-6
Lists the MAC address, IP address, and IPX network number for B-7
each VLAN or, if no VLANs are configured, for the switch.
Lists the module type and description for each slot in which a B-8
module is installed.
Displays the operational status of each port. B-9
Summarizes port activity and lists per-port flow control status. B-10
Lists the MAC addresses of nodes the switch has detected on B-13
specific VLANs, with the corresponding switch port.
Lists the MAC addresses that the switch has learned from the B-13
selected port.
Lists Spanning Tree Protocol data for the switch and for individual B-18
ports. If VLANs are configured, reports on a per-VLAN basis.
Lists IGMP groups, reports, queries, and port on which querier is B-20
located.
For each VLAN configured in the switch, lists 802.1Q VLAN ID and B-21
up/down status.
Shows port utilization and counters, and the Alert Log. B-23
B-4