Filter
Top Products
IP Routing Features
Configuring RIP
Not e ICMP Host Unreachable Message for Undeliverable ARPs. If the
routing switch receives an ARP request packet that it is unable to deliver to
the final destination because of the ARP timeout and no ARP response is
received (the routing switch knows of no route to the destination address),
the routing switch sends an ICMP Host Unreachable message to the source.
RIP Parameters and Defaults
The following tables list the RIP parameters, their default values, and where
to find configuration information.
RIP Global Parameters
3-3 lists the global RIP parameters and their default values.
Table 3-3. RIP Global Parameters
Parameter Description Default
RIP state Routing Information Protocol V2-only. Disabled
auto-summary Enable/Disable advertisement of summarized routes. Enabled
metric Default metric for imported routes. 1
redistribution RIP can redistribute static and connected routes. (RIP
redistributes connected routes by default, when RIP is
enabled.)
Disabled
RIP Interface Parameters
3-4 lists the VLAN interface RIP parameters and their default values.
Table 3-4. RIP Interface Parameters
Parameter Description Default
RIP version The version of the protocol that is supported on the
V2-only
interface.
The version can be one of the following:
• Version 1 only
• Version 2 only
• Version 1 or version 2
3-28