Filter
Top Products
3-11
Operating the Library
Setting and Viewing SCSI IDs
Library Operation
Setting and Viewing SCSI IDs
NOTE The tape library has a Fast/Wide SCSI interface. SCSI addresses can be set from:
• 0 to 7 on a DLT 4000-based library
• 0 to 15 on a DLT 7000-based library
If connecting to a narrow host, use only addresses 0 to 7.
When you choose SCSI IDs, you have two options:
• SET IDs * lets you assign individual SCSI IDs to each drive in the library and to
the library controller.
• VIEW IDs * lets you see the current drive and library controller settings.
The following table shows the default settings:
Table 3-1 Default SCSI IDs
If you are already using any of these IDs for your computer or another SCSI
peripheral device, follow the instructions in “Setting SCSI IDs” on page 3-12.
To view the current SCSI address settings, see “Viewing Current SCSI Address
Settings” on page 3-14.
1 2 → ADMIN * → SCSI IDs *
DEVICE SCSI ID BUS #
LIB ID 6 Bus 1
DRV 1 ID 5 Bus 1
DRV 2 ID (two-drive models only) 4 Bus 2