Filter
Top Products
3-32
Operating the Library
Running an Internal Test
Running an Internal Test
The library can run self-diagnostic tests. To run these tests, follow these steps:
CAUTION Some diagnostic tests can place tape cartridges in unexpected locations. These tests
should be run only by authorized service personnel.
1. Verify that the drive status displays. If not, press
CANCEL until it does.
2. Press
NEXT until ADMIN * appears in the display window, then press ENTER.
3. Enter the three-part numerical password (see “Entering the Administration
Menu Password” on page 3-9).
4. INFO * displays. Press
NEXT or PREV until TEST * displays, then press ENTER.
5. Press
NEXT until the name of the test to run displays, then press ENTER.
6. NUM LOOPS # displays, where the 1 is flashing. Press
NEXT until the number of
test loops you wish to run displays, then press
ENTER.
NOTE Press CANCEL at any time to abort a test. TEST CANCEL - WAIT displays while the
current test loop completes.
1 2 → ADMIN * → TEST *