Filter
Top Products
3-12
Operating the Library
Setting and Viewing SCSI IDs
Setting SCSI IDs
A SCSI ID is required for the robotics controller and each drive. The default IDs are
shown in Table 3-1 on page 3-11.
The following configuration choices are available:
Table 3-2 SCSI Address Configuration Options
To change the current SCSI address settings:
1. Verify that the drive status displays (if not, press
CANCEL until it does).
2. Press
NEXT until ADMIN * displays, then press ENTER.
3. Enter the three-part numerical password (see “Entering the Administration
Menu Password” on page 3-9).
4. Press
NEXT until SCSI IDs * displays, then press ENTER.
5. SET IDs * displays. Press
ENTER.
LIB BUS # ID # or DRV # BUS # ID # displays. LIB BUS # ID # stands for the
current SCSI ID of the robotics controller. DRV # BUS # ID # is the current
SCSI ID setting for the drive number and its associated bus #.
6. Press
NEXT until the setting to change displays, then press ENTER.
1 2 → ADMIN * → SCSI IDs * → SET IDs *
Number of
Drives
SCSI Bus Addresses Available
1 13 addresses are available on bus 1. (Drive 1 uses one address
and the library controller uses 1 address.)
2 If buses 1 and 2 are connected to separate host SCSI cards:
• 13 addresses are available on bus 1 for other devices.
• 14 addresses are available on bus 2 for other devices.
If buses 1 and 2 are daisy-chained:
• 12 addresses are available on the bus for other devices.