Filter
Top Products
HP SureStore DAT
Installation Guide
1-12
Using the Conversion Kit
1 Unscrew the four screws and remove the rails from the tape drive.
Figure 1.4 Removing the drive rails prior to installation in a 3½-inch bay
2
Use a screwdriver to release the 5¼-inch front panel from the tape drive
and remove it. Fit the 3½-inch front panel and push firmly until the
panel clicks into place.
Figure 1.5 Removing the 5¼-inch panel
Note: Some drives have
clips on the sides of the
unit.
Dat-int.bk Page 12 Wednesday, May 26, 1999 10:46 AM