Filter
Top Products
Removal and replacement procedures 45
2.
Power down the server (on page 25).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 27).
5. Remove the access panel ("Access panel" on page 28).
6. Remove the air baffle ("Air baffle" on page 29).
7. Loosen the screws, and then remove the graphic card bracket.
8. Open the PCI retainer latch.