Filter
Top Products
Removal and replacement procedures 52
9.
Remove all drives from the drive cage ("Drive" on page 35).
10. Loosen the thumbscrew on the drive backplane and remove it from the cage.
To replace the component, reverse the removal procedure.
Systems Insight Display assembly
CAUTION: When routing cables, always be sure that the cables are not in a position where they
can be pinched or crimped.
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 26).
o For rack models, if installed, remove the security bezel (on page 26).
2. Power down the server (on page 25).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel ("Access panel" on page 28).
5. For rack models, do the following:
a. Extend the server from the rack (on page 27).
b. Remove the access panel ("Access panel" on page 28).
c. Release thumbscrews and remove the rack bezel.
6. Disconnect the cable that connects the Systems Insight Display assembly to the system board.
7. Remove the thumbscrews securing the Systems Insight Display assembly.