Filter
Top Products
Removal and replacement procedures 49
SFF drive backplane
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 26).
o For rack models, if installed, remove the security bezel (on page 26).
2. Power down the server (on page 25).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel ("Access panel" on page 28).
5. For rack models, do the following:
a. Extend the server from the rack (on page 27).
b. Remove the access panel ("Access panel" on page 28).
c. Release thumbscrews and remove the rack bezel.
6. Disconnect all cables from the drive backplane.
7. Using a T-15 screwdriver, remove the screws that secure the SFF drive cage to the server.