Filter
Top Products
Removal and replacement procedures 32
To replace the component, reverse the removal procedure.
Hot-plug power supply
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Determine how many hot-plug power supplies are installed:
o If only one hot-plug power supply is installed, power down and remove the power cord from the
server ("Power down the server" on page 27).
o If more than one hot-plug power supply is installed, continue with the next step.
2. Access the product rear panel (on page 29).
3. Disconnect the power cord from the power supply.