Filter
Top Products
Removal and replacement procedures 36
2.
Extend or remove the server from the rack ("Remove the server from the rack" on page 28, "Extend the
server from the rack" on page 28).
3. Remove the access panel ("Access panel" on page 34).
4. Disconnect the cable from the optical drive.
5. Remove the optical drive ("Optical drive" on page 34).
6. Remove the optical drive cage.
To replace the component, reverse the removal procedure.
Hot-plug fan
CAUTION: To avoid damage to server components, fan blanks must be installed in fan bays 5
and 6 in a single-processor configuration.
The only two valid fan configurations are listed in the following table.