Filter
Top Products
Flash drive
Description Spare part number
1-GB flash drive (includes flash drive bracket) 465619-001
Before removing the flash drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off, turn the computer on, and then
shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 29).
Remove the flash drive:
1.
Position the computer with the front toward you.
2. Loosen the two Phillips PM2.0×6.0 captive screws (1) that secure the flash drive bay cover to the
computer.
3. Lift the right side of the flash drive bay cover (2), swing it to left, and remove the cover. The flash
drive bay cover is included in the Plastics Kit, spare part number 417527-001.
4. Grasp the Mylar tab (1) on the flash drive and pull the module (2) to the left to disconnect it from
the system board.
30 Chapter 4 Removal and replacement procedures