Filter
Top Products
9. Remove the system board frame and system board (3) from the base enclosure.
10. Release the modem module cable (1) from the two clips built into the system board.
11. Release the RJ-11 connector (2) from the clip built into the system board.
12. Remove the three Torx T8M2.5×4.0 screws (3) that secure the system board to the system board
frame.
13. Remove the two Hex HM5.0×11.0 screw locks (4) that secure the system board to the system board
frame.
14. Lift the front edge of the system board (1) until it rests at an angle.
54 Chapter 4 Removal and replacement procedures