Filter
Top Products
Hard drive or SSD
NOTE: The hard drive spare part kit does not include the hard drive connector cable, isolators, or
shield. The hard drive connector cable, isolators, and shield are included in the Hard Drive Hardware
Kit, spare part number 639444-001. The hard drive connector cable is included in the Cable Kit, spare
part number 640206-001.
Description Spare part number
For use with all computer models:
750 GB, 5400 rpm, 9.5 mm (0.37 in) × 6.35 cm (2.50 in), 644351-001
640 GB, 5400 rpm, 9.5 mm (0.37 in) × 6.35 cm (2.50 in) 637312-001
500 GB, 7200 rpm, 9.5 mm (0.37 in) × 6.35 cm (2.50 in) 644685-001
320 GB, 7200 rpm, 7.0 mm (0.28 in) × 6.35 cm (2.50 in) 645089-001
160 GB SSD, 6.35 cm (2.50 in) 682589-001
Before removing the hard drive or SSD, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 37).
5. Remove the service door (see
Optical drive on page 39).
Remove the hard drive or SSD:
1. Disconnect the drive connector cable (1) from the system board.
2. Lift the front edge of the drive (2) until it rests at an angle.
Component replacement procedures 41