Filter
Top Products
Removal and replacement procedures 49
To remove a memory module:
1. Perform the procedure on the “Remove the system board” section on page 5.
2. Remove any accessory boards or cables that prevent access to the DIMM slots.
3. Remove the memory module.
To install a memory module:
1. Locate an empty DIMM slot on the system board.
2. If necessary, open the holding clips of the selected DIMM slot.
3. Remove the memory module from its protective packaging, handling it by the edges.
4. Install the memory module.
a. Open the DIMM slot latches.
b. Align the notch on the bottom edge of the memory module with the keyed surface of the
DIMM slot, and then fully press the memory module into the slot until the latches snap back
into place.
The DIMM slots are structured to ensure proper installation. If you insert a memory module but
it does not fit easily into the slot, you may have inserted it incorrectly. Reverse the orientation
of the module and insert it again.