Filter
Top Products
Removal and replacement procedures 59
7. Install the replacement power supply unit in the chassis:
IMPORTANT: Check the PSU cable label before connecting them. Go to page 35 for a
reference figure on proper PSU cable connections.
8. Connect the power cables:
a. Connect the power cable P1 to the 24-pin power connector on the system board (J12).
b. Connect the power cable P2, P3, P4 and P5 to hard drives 1, 2, 3 and 4 respectively.
c. Connect the power cable P6 to the ODD and connect the ODD cable.
d. Fasten the three screws on the back of chassis to secure the power supply unit (see the picture
above).
9. After installing the power supply and connecting the power cables, slide the top panel to reinstall
it into the chassis.
10. Fasten the rear thumbscrew to secure the top panel on the chassis.
11. Close the front panel door of the server.
12. Use the HP ProLiant MicroServer key to lock the panel door.