Filter
Top Products
Removal and replacement procedures 52
HP ProLiant MicroServer Remote Access Card
This document provides instructions for installing the Remote Access Card in your HP ProLiant
MicroServer. This option allows users to perform server access tasks remotely over a LAN or the
Internet. The connector is shown in the figure below.
Installation guidelines
The procedures in this document are intended for individuals who are qualified in the servicing of
computer equipment and trained in recognizing hazards in products with hazardous energy levels.
WARNING: Failure to properly turn off the server before you open the server or before you start
removing or installing hardware components may cause serious damage as well as bodily harm.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the chassis and any
installed hardware component to cool before touching them.
CAUTION: Observe ESD safety precautions when handling any hardware component.
IMPORTANT: Observe the pre-installation procedure before installing the IPMI card.
To install the Remote Access Card:
1. Follow the steps of removing the system tray out of the chassis.
2. Lift the Remote Access Card to release it from the connector (1).