Filter
Top Products
Installing the Software 23
G:\TW\Lori\Raptor\C4388-90100\exraptor1.fm Page 23
Last Modified: Tuesday, January 27, 1998 8:33 pm
Printing date: Saturday, April 04, 1998
Installing Colorado Backup for Windows 95
NOTE: Do not use Colorado Backup for Windows 95 to backup Novell servers.
Colorado Backup for DOS can backup Novell 2.x and 3.x servers or Colorado
Backup for Windows (3.1 or 3.11) can backup Novell 3.x servers.
NOTE: Colorado Backup for Windows 95 can back up computers over your Windows
95 and Windows for Workgroups networks. However, Colorado Backup for Windows
95 will only back up the Windows 95 registry of the computer to which your tape
drive is attached. The Windows 95 registry of a remote computer will not be backed
up.
1. You will need two formatted, 3.5” (1.44 MB) diskettes labeled “Recovery Disk #1”
and “Recovery Disk #2” to use in step 13.
2. Connect the tape drive to your parallel port as described in “Connecting the
Hardware” on page 4. The drive must be attached to install and configure the
software.
3. Insert the software installation CD into your CD-ROM drive. If your computer does
not have a CD-ROM, see page 35.
4. If the first screen does not appear automatically, click the
Start
button on the
Windows 95 task bar, select
Run
, type D:\SETUP (where D: is your CD-ROM’s
drive letter), then click on
OK
. The following screen appears: