Filter
Top Products
Troubleshooting
32 AB232A PCI-X Host Bus Adapter Installation Guide
Windows Miniport Event Log Codes
The Windows Miniport driver logs events and errors in the Windows Event log.
Serious errors are always logged. Informational events are only logged if the
registry parameter LogError=1 is used.
All Miniport logged events are issued with an Event ID of 11 (INTERNAL
ADAPTER ERROR) but do not necessarily indicate an HBA error occurred. Byte
offset 0x10 of the event is the driver event code. Byte offsets 0x11 to 0x13 contain
event-specific information.
Table 5 describes the SCSI port error log codes.
Table 5: SCSI Port Error Log Codes
0x10
Offset
Explanation 0x11 to 0x13 Further Information
0xD0 SNS_REQ (XMIT_SEQ
failed)
0x11 = cmdstat, 12 = parm err
0xD1 SNS_RSP (RCV_SEQ
failed)
0x11 = cmdstat, 12 = parm err
0xD3 RCV_ELS_REQ failed 0x11 = cmdstat, 12 = parm err
0xD4 XMT_ELS_REQ failed 0x11 = cmdstat, 12 = parm err
0xD5 Too many targets found
(160+)
0x11 to 13 = D_DID that didn’t fit
0xD6 SNS request time-out 0x11 to 13 = no additional information
0xD7 Mailbox interrupt time-out 0x11 = mailbox word 0
0xD8 TPRLO requested when
busy
0x11 = local req. state, 12 =
discstate, 13 = mailbox word 0
0xD9 Link down time-out
occurred
0x11 = local req. state, 12 =
discstate, 13 = mailbox word 0
0xDA Hard link down time-out
occurred
0x11 = local req. state, 12 =
discstate, 13 = mailbox word 0
0xE1 Error interrupt occurred Status register bytes 1–3 in event
11–13. E1 error indicates an HBA
hardware failure, return HBA for
repair.
0xE2 Mailbox cmd time-out 0x11 = command