Filter
Top Products
Reverse this procedure to reassemble and install the hard drive.
Fingerprint reader board
Description Spare part number
Fingerprint reader board (includes bracket and cable) 693349-001
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 45).
5. Remove the service cover (see
Service cover on page 47).
6. Remove the hard drive (see
Hard drive on page 48).
Remove the fingerprint reader board:
1. Release the zero insertion force (ZIF) connector to which the fingerprint reader board cable is
attached, and then disconnect the fingerprint reader board cable (1) from the SD Card
reader board.
2.
Remove the Phillips PM2.0×2.0 screw (2) that secures the fingerprint reader board bracket to the
top cover.
50 Chapter 4 Removal and replacement procedures