Filter
Top Products
Bluetooth module cable
NOTE: The Bluetooth module cable is included in the Cable Kit, spare part number 652545-001.
Before removing the Bluetooth module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 51).
5. Remove the service access cover (see
Service access cover on page 52).
6. Remove the optical drive (see
Optical drive on page 63) or upgrade bay hard drive (see Upgrade
bay hard drive on page 66).
7. Remove the keyboard (see
Keyboard on page 71).
8. Remove the top cover (see
Top cover on page 83).
9. Remove the bluetooth module (see
Bluetooth module on page 59).
10. Remove the card reader/USB 3.0 board (see
Card reader/USB 3.0 board on page 102).
Remove the Bluetooth module cable:
1. Position the computer right-side up with the front toward you.
2. Disconnect the Bluetooth cable (1) from the system board.
3. Remove the Bluetooth cable (2).
Reverse this procedure to install the Bluetooth module cable.
System board
NOTE: All system board spare part kits include replacement thermal material.
Component replacement procedures 103