Filter
Top Products
Service menu
Use this menu to restore default settings, clean the product, and activate special modes that affect print
output.
Menu item Sub-menu item Description
Cleaning mode Use this option to clean the product if you see toner specks or
other marks on the printed output. The cleaning process
removes dust and excess toner from the paper path.
When you select this item, the product prompts you to load
plain paper in tray 1 and then press OK to start the cleaning
process. Wait until the process is complete. Discard the page
that prints.
PowerSave Sets how long the product remains idle before it enters
PowerSave mode. The product automatically exits
PowerSave mode when you send a print job or press a control-
panel button.
The default setting is 15 minutes.
USB speed High
Full
Sets the USB speed to High or Full. For the product to actually
operate at high speed, it must have high speed enabled and
be connected to an EHCI host controller that is also operating
at high speed. This menu item also does not reflect the current
operating speed of the product.
The default setting is High.
Less paper curl Off
On
If printed pages are consistently curled, use this option to set
the product to a mode that reduces curl.
The default setting is Off.
Archive print Off
On
If you are printing pages that will be stored for a long time, use
this option to set the product to a mode that reduces toner
smearing and dusting.
The default setting is Off.
Restore defaults Yes
No
Sets all customized settings to the factory default values.
14 Chapter 2 Control panel ENWW