Filter
Top Products
CheXpress® CX30 User’s Manual_Rev 020309
the scanner document track. If feeding problems are still experienced, try cleaning the
scanner using a CheXpress® cleaning card and the procedures described within this
users guide.
Check Images are streaking or fading
If you notice either streaking or fading on the images, the scanheads may require
cleaning. Refer to the section below on cleaning the scanheads.
CheXpress® CX30 Operator Maintenance
Cleaning the CheXpress® CX30
Over time, ink, dirt and dust particles will collect on the scanner rollers and document
track. Therefore, it is necessary to clean these areas on a regular basis to assure
reliable performance. Tips for performing preventative maintenance by the user on the
CheXpress® CX30 include:
• A Periodic inspection of the document track area can be done. You can open the
outer scanhead door to look at each scanhead. (fig. 10)
• Have a can of compressed air available to blow out the document track on a
regular basis. The area below the outer scanhead is a dust collection bin. Be
sure to blow out this area when doing periodic cleaning.
• Purchase the CheXpress® cleaning cards to have on hand for regular cleaning
maintenance. Run several scan cycles, flipping the card between cycles. Allow
the card to scan through the entire path with the exit door open. Run this through
several times while flipping the card end to end and top to bottom.
• Inspect the quality of the captured images on a regular basis. If the image quality
drops off, inspect and clean the scanheads following the procedure to open the
out scanhead door and wipe down the camera surfaces. If this does not correct
the problem, contact your service provider.
15