Filter
Top Products
CheXpress® CX30 User’s Manual_Rev 020309
3. Connect the power cord for the external power supply to the power supply and then
plug in the connector into the bottom access, but do not connect to the power source
until the driver has been loaded.
4. Connect the USB cable by plugging it into the bottom access port.
5. Note: Route the two cords through any of the three cable channels to provide the
best routing for you environment.
6. Make sure the CheXpress® CX30 is unplugged from power outlet. Verify that the red
power indicator on the Control Panel is not lit. Keep the power supply unplugged
from the power source until the USB driver has been loaded onto PC.
Installing the Rear Endorser Inkjet Cartridge
Follow these instructions when installing the inkjet cartridge for the first time, or when
replacing an empty cartridge:
Fig. 5
Fig. 4
1. Gently pull out on the tabs on the top scanner cover. Lift up on the cover for access
to the inkjet platform.
2. If replacing an existing cartridge, remove the inkjet cartridge by grasping the small
tab at the rear end and gently pulling upward. Discard the used cartridge.
3. Obtain a new inkjet cartridge (HP part number C6602A). For new installations, one
new cartridge is included with each inkjet model scanner. Be certain to read the
instructions included with the cartridge.
4. Remove the protective tape covering the ink nozzles. Be careful not to touch the ink
nozzle with your fingers or allow it to come in contact with any clothing.
7