Filter
Top Products
Speaker assembly
Description Spare part number
Speaker assembly 709456-001
Before removing the speaker assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4.
Remove the display assembly (see
Display assembly on page 26).
5. Remove the system board (see
System board on page 42).
6. Remove the battery (see
Battery on page 54).
7. Remove the docking connector (see
Docking connector cable on page 56).
Remove the speaker assembly:
1. Release the tabs (1) built into the bottom case that secure the speaker cable.
2. Remove the four Phillips PM1.4×2.3 screws (2) that secure the speaker assembly to the
bottom case.
3.
Remove the speaker assembly (3).
Reverse this procedure to install the speaker assembly.
58 Chapter 4 Removal and replacement procedures