Filter
Top Products
4 Hardware options installations
In this section
• “Introduction” (page 39)
• “Processor options” (page 39)
• “Memory options” (page 46)
• “Hard drive guidelines” (page 47)
• “Installing DVD or CD drive” (page 48)
• “Hot-plug power supplies” (page 49)
• “Expansion boards” (page 51)
• “Battery-backed write cache” (page 53)
Introduction
If you plan to install more than one hardware option, read the installation instructions for all the
hardware options and identify similar steps to streamline the installation process.
WARNING! To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
Review Chapter 9 (page 91) before installing hardware options into the server.
Processor options
The server supports a four- or eight-processor configuration.
CAUTION: The cell filler is required in cells 3 – 6 in a four-processor configuration.
Removing the processor memory cell and airflow baffle
To remove the processor memory cell and airflow baffle:
1. Power down the server, see “Power down the server” (page 31).
2. Press the release button.
3. Open the lever.
4. Grasp the lever and slide the processor memory cell out of the enclosure. Place a hand under
the component to support it as you remove it from the enclosure.
Introduction 39