Filter
Top Products
Solid-state drive
Description Spare part number
160-GB solid-state drive for use on all computer models 682098-001
32-GB solid-state drive for use only on computer models equipped with an Intel processor 682099-001
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 46), and then remove the following components:
a. Hard drive (see
Hard drive on page 47)
b.
Optical drive (see
Optical drive on page 54)
c. Keyboard (see
Keyboard on page 57)
d. Top cover (see
Top cover on page 61)
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
70 Chapter 4 Removal and replacement procedures