Filter
Top Products
Before removing the system board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 46).
5.
Remove the hard drive (see
Hard drive on page 47).
6. Disconnect the wireless antenna cables from the WLAN module (see
WLAN module on page 52).
7. Remove the following components:
a. Optical drive (see
Optical drive on page 54)
b. Keyboard (see
Keyboard on page 57)
c. Top cover (see
Top cover on page 61)
When replacing the system board, be sure that the following components are removed from
the defective system board and installed on the replacement system board:
●
Memory module (see
Memory module on page 51
●
WLAN module (see
WLAN module on page 52
●
Solid-state drive (see
Solid-state drive on page 70)
●
Fan/heat sink assembly (see
Fan/heat sink assembly on page 77)
●
Processor (see
Processor on page 82)
Remove the system board:
1.
Close the computer.
2. Turn the computer upside down, with the front toward you.
3. Disconnect the RTC battery cable (1) from the system board.
Component replacement procedures
73