HP (Hewlett-Packard) FN038UAABA Laptop User Manual


 
System Configuration menu
NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
Boot Options
Set a Startup Menu delay (in seconds).
Enable/disable Custom Logo (disabled by default).
Enable/disable Display Diagnostic URL (enabled by
default).
Enable/disable CD-ROM boot (enabled by default).
Enable/disable SD Card boot (enabled by default).
Enable/disable floppy boot (enabled by default).
Enable/disable PXE Internal NIC boot (enabled by
default).
Set the Express Boot Popup delay in seconds.
Set the boot order.
Device Configurations
Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the
following:
Use of a USB keyboard in Computer Setup even
when a Windows operating system is not running.
Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
Select a parallel port mode: ECP (Enhanced Capabilities
Port), standard, bidirectional, or EPP (Enhanced Parallel
Port).
Enable/disable fan always on while connected to an AC
outlet (enabled by default).
Enable/disable LAN Power Save (select models only).
When enabled, saves power by turning off the LAN when
not in use (enabled by default).
Enable/disable Data Execution Prevention. When
enabled, the processor can disable some virus code
execution, which helps to improve computer security.
SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
AHCI (Advanced Host Controller Interface)
IDE (Integrated Drive Electronics)
RAID (select models only)
96 Chapter 5 Computer Setup