Filter
Top Products
3.10 Paper Handling
3-91
Step 3. Selecting the Fuser Mode
1
Complete Step 2. above.
2
Press the V key.
3
Press the U or V key repeatedly until >>Fuser Mode appears.
4
Press the ENTER key. A blinking question mark (?) appears.
5
Press the U or V key to display the desired fuser mode from the following:
Low
Middle
6
When the desired fuser mode is displayed, press the ENTER key. Proceed to the next
step.
Enabling or Disabling Duplex Printing for Custom Paper Type
This parameter is valid for the FS-8000CD printer which is equipped with the duplexer as a
standard feature. When this parameter is disabled for a Custom type, the printer does not
duplex print when the custom size is selected for the paper type in a print job.
By default, duplex printing is enabled for custom paper types. To confirm and change this,
proceed as follows:
1
Complete Step 1. above.
2
Press the Z key.
3
Press the U or V key repeatedly until >>Duplex path appears.
>>Fuser Mode
Middle
>>Fuser Mode
? Middle
>>Duplex path
Enable