Filter
Top Products
3.5 Changing the Interface Parameters
3-40
6
Press the Z key. One of the following serial parameters is indicated (
Baud rate
for
example).
Pressing the U or V key toggles through the serial parameters as follows. To change
the serial parameter, press the ENTER key. Use the U or V key to change the value or
selection.
For example, to change baud rate from 9600 to 115200, display the baud rate menu following
the above procedure. When the display shows baud rate, 9600 (bps), press the ENTER key. A
blinking question mark (?) appears.
Range
>Baud rate
9600
1200, 2400, 4800, 9600 (Default), 19200, 38400, 57600,
115200
>Data bits
8
7 or 8 (Default)
>Stop bits
1
1 (Default) or 2
>Parity
None
None (Default), Odd, Even, or Ignore
>Protocol
DTR(pos.)&XON
DTR (pos.) & Xon (Default), DTR (positive), DTR (neg-
ative), Xon/Xoff, ETX/ACK
>Barcode Mode
Off
Off (Default) or On
†
† Barcode mode is used when the option barcode reader is connected to the printer to support
reading document IDs (barcodes). Note that Barcode Mode appears in the menu only when
a hard disk option is installed.
>Baud Rate
? 9600