Filter
Top Products
Display assembly
Description Spare part number
39.6-cm (15.6-in) High Definition (HD), light-emitting diode (LED) BrightView display assembly:
●
For use in Charcoal Grey computer models 639512-001
●
For use in Ocean Drive computer models 639513-001
● For use in Sonoma Red computer models 639514-001
●
For use in Luminous Rose computer models 639515-001
●
For use in Pewter computer models 639516-001
● For use in Pacific Blue computer models 639517-001
●
For use in Pearl Pink computer models 639518-001
●
For use in Sweet Purple computer models 639519-001
● For use in Butter Gold computer models 639520-001
Before removing the display assembly, remove the following components:
1. Battery (see
Battery on page 40)
2. Service access cover (see
Service access cover on page 41)
3. Optical drive (see
Optical drive on page 44)
4. WLAN module (see
WLAN module on page 46)
5. Keyboard (see
Keyboard on page 50)
6. Top cover (see
Top cover on page 52)
7. USB board (see
USB board on page 59)
Remove the display assembly:
1. Turn the computer right-side up, with the front toward you.
2. Open the computer as far as possible.
3. Disconnect the display panel cable (1) from the system board and remove it from its routing
channel.
4. Pull the antenna cables through the opening in the base enclosure (2), and then disengage the
cables from the clip in the routing channel leading to the display hinge.
CAUTION: Support the display assembly when removing the display screws in the following
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
5. Remove the five Phillips 6.0 x 2.5 screws (3) that secure the display assembly to the computer.
62 Chapter 4 Removal and replacement procedures ENWW