Filter
Top Products
7. To replace any of the display assembly internal components, remove the following screw covers
and screws:
(1) Two Mylar screw covers on the display bezel bottom edge
(2) Two Phillips 4.0 x 2.5 screws
The display screw covers are included in the Display Rubber Kit, spare part number
640882-001.
8. Flex and lift up on the inside edges of the bezel on the left side (1), the top and bottom (2), and
the right side (3) until the bezel disengages from the display back cover.
9. Remove the display bezel (4).
Reverse this procedure to install the display bezel.
64 Chapter 4 Removal and replacement procedures ENWW