Filter
Top Products
Display assembly
Description Spare part number
39.6-cm (15.6-in) High Definition (HD), light-emitting diode (LED) BrightView display assembly:
●
For use in Charcoal Grey computer models 645523-001
●
For use in Ocean Drive computer models 636378-001
● For use in Sonoma Red computer models 645521-001
●
For use in Luminous Rose computer models 645522-001
●
For use in Pewter computer models 645524-001
● For use in Pacific Blue computer models 645525-001
●
For use in Pearl Pink computer models 645526-001
●
For use in Sweet Purple computer models 645527-001
● For use in Butter Gold computer models 645528-001
Before removing the display assembly, remove the following components:
1. Battery (see
Battery on page 44)
2. Service access cover (see
Service access cover on page 45)
3. Optical drive (see
Optical drive on page 48)
4. WLAN module (see
WLAN module on page 50)
5. Keyboard (see
Keyboard on page 53)
6. Top cover (see
Top cover on page 56)
7. USB board (see
USB board on page 63)
8. Power connector (see
Power connector on page 64)
Remove the display assembly:
1. Position the computer display-side up, with the front toward you.
2. Open the display as far as possible.
3. Disconnect the display panel cable (1) from the system board.
4. Pull the antenna cables through the opening in the base enclosure (2), and then disengage the
cables from the clip in the routing channel leading to the display hinge.
CAUTION: Support the display assembly when removing the display screws in the following
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
5. Remove the two Phillips 6.0×2.5 screws (3) that secure the display assembly to the computer.
ENWW Component replacement procedures 65