Filter
Top Products
6-4
Message Value Description
IPX/SPX
DLC/LLC
TCP/IP
ETALK
ON
OFF
Selects whether or not a protocol is
enabled or disabled. Change it to OFF
to disable a protocol.
CFG IPX/SPX NO
YES
Selects whether you want to access the
IPX/SPX menu and set the IPX/SPX
protocol parameters.
In the IPX/SPX menu, you can specify
the Frame Type parameter used on your
network.
• The default is AUTO, which
automatically sets and limits the Frame
type to the one detected.
• For Ethernet cards, frame type
selections include EN_8023, EN_II,
EN_8022, EN_SNAP.
• For Token Ring cards, frame type
selections include TR_8022, TR_SNAP.
In the IPX/SPX menu for Token Ring
cards, you can also specify NetWare
Source Routing parameters, which
include SRC RT=AUTO (default), OFF,
SINGLE R or ALL RT.
CFG TCP/IP NO
YES
Selects whether you want to access the
TCP/IP menu and set the TCP/IP
protocol parameters.
In the TCP/IP menu, you can specify
BOOTP=YES for TCP/IP parameters to
be automatically configured by a BootP
or DHCP server when the printer is
turned on.
If you specify BOOTP=NO, you can
manually set the following TCP/IP
parameters from the control panel:
Each byte of the IP address (IP)
• Subnet Mask (SM)
• Syslog Server (LG)
• Default Gateway (GW)
• Idle Timeout period (default is 90
seconds, 0 disables the timeout)
When setting IP numbers, press the
Value button to increase the number by
1. Hold down the Value button to
increase the number by 10. 2. Press the
Resume button to make your selection.