Filter
Top Products
Note
Access the Interconnect PCA Housing by laying
the printer on the rear of the printer chassis.
4
Disconnect the Interconnect Cable connector from the DC
Controller (J210 on LJ4, J213 on LJ4+/5). Remove the cable
from its retainer.
5 Release the bottom or rear-most latch (see Figure 6-59),
callout 1) holding the arm of the Interconnect PCA housing to
the sheet metal.
6
Rotate the bottom (rear) of the PCA housing up (toward the
front) to release the housing from the printer.
(continued on next page)
Figure 6-59 Interconnect PCA latches and AC Connector
Mounting Pins
6-70 Removal and Replacement