Filter
Top Products
2
HP Netserver High Density Rack Solutions Overview (LP 2000r)
Safety and Regulatory Information
For your protection, Hewlett-Packard products are tested for conformance to various national and interna-
tional regulations and standards. The scope of this regulatory testing includes electrical and mechanical
safety, electromagnetic emissions, immunity, ESD, and hazardous materials.
Where required, certifications are obtained from third party test agencies. Certification marks, when
required, appear on the product label. In addition, various regulatory bodies require some information
under the headings below.
These products and related documentation must be reviewed for familiarization with safety markings and
instructions before operation.
WARNING The WARNING sign denotes a hazard. It calls attention to a procedure, practice, or
situation which, if not done correctly or adhered to, could result in injury. Do not proceed
beyond a WARNING sign until the indicated conditions are fully understood and met.
CAUTION The CAUTION sign denotes a hazard. It calls attention to an operating procedure, practice,
or situation which, if not done correctly or adhered to, could damage or destroy part or
the entire product. Do not proceed beyond a CAUTION sign until the indicated conditions
are fully understood and met.
Safety Warnings
The following warnings and cautions are applicable to the System/E rack. Please observe all safety
precautions and warnings.
This product has not been evaluated for connection to an IT power system (an AC distribution system hav-
ing no direct connection to earth (ground) according to EN60950.
Grounding
WARNING The HP System/E Racks are safety class I product and has a protective earthing
(grounding) terminal. There must be an uninterruptible safety earth ground from the main
power source to the product’s input wiring terminals, power cord, or supplied cord set.
Whenever it is likely that the protection has been impaired, disconnect the power cord
until the ground has been restored.
Leakage Current
WARNING Due to types of products that can be installed in the System/E rack, there is a risk of high
leakage current (3.5 mA). Reliable ground circuit continuity is vital for safe operation of
this product. To reduce the risk of electric shock, earth (ground) connection is essential
before connecting the power supply. Never operate this cabinet with the ground
conductor disconnected.
Power Limitations
CAUTION To reduce the risk of overload, do not load any single Power Distribution Unit (PDU) or
IEC-320C19 receptacle with more than a maximum of 16 A. In addition, do not load a single
NEMA 5-15 or IEC-320 C13 receptacle with more than a maximum of 10 A.
Cabinet Stability
CAUTION To reduce the risk of cabinet instability, deploy the anti-tip feet before installing or
extending any devices. Extend only one device at a time. Do not stand or sit on any
extended device. Qualified service personnel should do all non-operator servicing.
Accessories
CAUTION This product is designed for use with specific electrical accessories. The use of any other
accessory is not recommended or supported.