Filter
Top Products
4. Lower the output tray.
5. Pull out the extension on the output tray.
NOTE: For media longer than 11 inches (279 mm), pull the extension out to
the maximum extended position.
To load Tray 2
1. Pull the tray out of the device by grasping the front of the tray.
2. Slide the media guides out to the widest setting.
3. Insert the media print-side down in the center of the tray, make sure the media
does not exceed the line marking in the tray. Slide the media guides towards the
center until they touch the left and right sides of the media, and then gently push
the paper stack to the back of the tray.
NOTE: Do not load paper while the device is printing.
4. Gently reinsert the tray.
5. Pull out the extension on the output tray.
NOTE: For media longer than 11 inches (279 mm), pull the extension out to
the maximum extended position.
Configure trays
NOTE: Tray 2 is sold as an accessory. For ordering information, see Accessories.
To configure trays, you must have Tray 2 installed and turned on in the printer
driver.
Configure trays
23